Navigation¶

• Main Page
  

• Random Page
• Create a new Page
• All Pages
• Categories
  

• File Management
  

• Create Account
  

• Help Topics
  

Filter by Category

Farm Motors-Stationary Steam Engines — 25.0%

[...] Fig. 62, and the bolts are put in, the heads of the bolts being at the bottom in recesses of cast-iron anchor plates marked P . Often the foundation bolts are threaded at both ends and the anchor [...]

Main Page — 12.5%

[...] Powermatic Paint Colors Powermatic Serial Numbers 3.24 - Shopsmith Buying a used Shopsmith Mark V anchor 3.25 - South Bend Lathe Works South Bend [...]

Steam Engine Foundations — 12.5%

[...] spread over the bottom of the excavation, on top of which the brick-work is laid. The fastening of the anchor bolts is shown in Fig. 6, consisting of a [...]

Unisaw Bullet Motor Repair — 12.5%

[...] pair of snap-ring pliers are an almost essential hand tool needed to get the ring loosened from its anchor groove. Use caution when trying to pry it [...]

Crescent 36" Band Saw Restoration — 12.5%

[...] was, however, a few pieces left in the small holes drilled in the shell though (which are used to help anchor the bearing in place.) To remove the old bearing [...]

Development of the Steam Traction Engine in America (Part 2) — 12.5%

[...] one headland and drawing the plows back and forth by means of the round about cable system, requiring anchor block and guide pulleys at the other three [...]

Babbitt - Pouring High Speed Bearings — 12.5%

[...] mandrel parallel with the planed ways of the yokes. Clean out all old babbitt, especially that in the anchor holes and plug up any oil holes or chambers [...]