Assembling a Delta Lathe Compound Slide Rest

Modified on 2018/09/16 21:54 by Jeff Joslin — Categorized as: Uncategorized

by Bill Nance

Introduction

This page shows the process and parts involved in assembling a compound slide rest for a Delta 12" wood lathe. The part numbers referenced in this page are taken from manual #PM-1533, dated 1/15/1948. Reprints can be found at: Delta Compound Slide Rest Manual #PM-1533.

While one might expect the reassembly to start with the sub-base, that is actually the final step. Access is needed inside the base, so instead we start with the base and lower feed screw.

Base, DDL-226-R

Base, DDL-226-R


The first step is to install the lower feed screw assembly within the base.

Exploded parts of Lower Feed Screw assembly, DDL-233-S

Exploded parts of Lower Feed Screw assembly, DDL-233-S


Lower Feed Screw assembly installed in Base

Lower Feed Screw assembly installed in Base


After assembling the base and lower feed screw, the next step is to install the upper feed screw assembly within the swivel saddle.

Exploded parts of Upper Feed Screw Assembly, DDL-232-S

Exploded parts of Upper Feed Screw Assembly, DDL-232-S


Upper Feed Screw installed in Swivel Saddle, DDL-228

Upper Feed Screw installed in Swivel Saddle, DDL-228


Once the two feed screw mechanisms are assembled, the two assemblies are attached using the lower slide. Square-head T-bolts are installed within slots in the lower slide, and then a steel pin, DDL-248, is installed through the lower slide into the indexed lower cylinder on the saddle. The lower slide gib, DDL-251, needs to be installed and adjusted along the dovetailed way.

Lower Slide, DDL-227

Lower Slide, DDL-227


Bottom view of base, lower slide and swivel saddle assembled

Bottom view of base, lower slide and swivel saddle assembled


Top view of base, lower slide and swivel saddle assembled, Lower Slide Gib not yet installed

Top view of base, lower slide and swivel saddle assembled, Lower Slide Gib not yet installed


Once the three main castings are assembled, the top slide is attached. The Upper Slide Gib, DDL-252, needs to be installed and adjusted along the dovetailed way.

Top slide to be installed w/ gib on dovetailed way

Top slide to be installed w/ gib on dovetailed way


The last assembly step is to install the Sub Base on the bottom of the entire assembly.

Sub Base ready for mounting, CBL-405

Sub Base ready for mounting, CBL-405


Sub Base installed using Special Hex Socket Cap Screws, CBL-430

Sub Base installed using Special Hex Socket Cap Screws, CBL-430


Finally, the cross slide is mounted on the lathe bed using two standard lathe clamp plates, CBL-406.

Cross Slide 46-965 installed on lathe

Cross Slide 46-965 installed on lathe