Jointer And Planer Knife Setting Videos

Modified on 2018/09/16 21:52 by Jeff Joslin Categorized as Maintenance

{rating}
==Bob Vaughan's Videos on YouTube ==
[https://www.youtube.com/watch?v=VRnrWOwun68|Jointer Knife Setting]

[https://www.youtube.com/watch?v=uSM7Jrg34a8|Planer Knife Setting]

[https://www.youtube.com/watch?v=p7peFNT2vS0|Combined Jointer and Planer Videos]

[http://vintagemachinery.org/files/PDF/FAQ/JointerKnives.pdf|Setting Jointer Knives - The FWW Article by Bob Vaughan]

==Setting Planer Knives==

If the planer's bed is adjusted parallel to the cutterhead, then the cutterhead becomes a datum reference surface too, so setting the knives parallel to the cutterhead will make them parallel to the bed. It's also easier to use the cutterhead as a reference surface because you can work from the top rather than indicate from underneath, rotate the cutterhead up, adjust and re-tighten the knife, kneel down, rotate the knife down, and check the new setting. Been there years ago. Didn't like it much. {Reference:http://owwm.org/viewtopic.php?t=197731|http://owwm.org/viewtopic.php?t=197731}

Meta Keywords:
Meta Description:
Change Comment: Change owwm.com to VM.org

	Welcome Guest, • Login
Wiki Home \| VintageMachinery.org Home \| OWWM.org Home \| Donate	Search the Wiki: »